IEEE 2018 Power Electronics/Power Systems

IEEE 2018 Power Electronics/Power Systems Project Titles
1.Active Power Quality Improvement Strategy for Grid -connected Microgrid Based on Hierarchical Control
2.A LLC-LC Type Bidirectional Control Strategy for LLC Resonant Converter in Power Electronic Traction Transformer
3.BLDC Motor Drive Based on Bridgeless Landsman PFC Converter with Single Sensor and Reduced Stress on Power Devices
4.Commutation Torque Ripple Reduction in BLDC Motor Using Modified SEPIC Converter and Three-level NPC Inverter
5.A PLL Based Novel Commutation Correction Strategy for High-Speed Brushless DC Motor Sensorless Drive System
6.Commutation Failure Elimination of LCC HVDC Systems using Thyristor-Based Controllable Capacitors
7. A Novel Single-Input Dual-Output Three Level DC-DC Converter
8.Control of D-STATCOM During Unbalanced Grid Faults Based on DC Voltage Oscillations and Peak Current Limitations
9.A Two Degrees of Freedom Resonant Control Scheme for Voltage Sag Compensation in Dynamic Voltage Restorers
10.Adaptive Fuzzy Logic Control of Fuel-Cell-Battery Hybrid Systems for Electric Vehicles
11.Single-Switch, Wide Voltage-Gain Range, Boost DC–DC Converter for Fuel Cell Vehicles
12.Repetitive Controller of Capacitor-Less Current-Fed Dual-Half-Bridge Converter for Grid-Connected Fuel-Cell System
13.Improved Direct Power Control for Grid-Connected Voltage Source Converters
14.Transient Characteristics Under Ground and Short-Circuit Faults in a ±500 kV MMC-Based HVDC System with Hybrid DC Circuit Breakers
15.Quasi-Z-Source Indirect Matrix Converter Fed Induction Motor Drive for Flow Control of Dye in Paper Mill
16.Predictive Torque Control Implementation for Induction Motors Based on Discrete Space Vector Modulation
17. Flexible Grid Connection and Islanding of SPC-based PV Power Converters
18.LVRT Performance Enhancement of DFIGBased Wind Farms by Capacitive Bridge-Type Fault Current Limiter (CBFCL)
19.MPPT Method for PV Systems under Partially Shaded Conditions by Approximating I-V Curve
20.Single-Phase PFC Converter using Switched – Capacitor for High Voltage DC Applications
21.A Modified Hybrid Modulation Strategy for Suppressing DC Voltage Fluctuation of Cascaded H-Bridge Photovoltaic Inverter
22.PV Battery Charger Using an L3C Resonant Converter for Electric Vehicle Applications
23.Synthesis and Design of the AC Current Controller and Impedance Network for the Quasi-Z-Source Convertor
24.High Step-Up Resonant DC/DC Converter with Ripple-Free Input Current for Renewable Energy Systems
25.New technique for using SMES to limit fault currents in wind farm power systems
26.A New Fault Tolerant Strategy for a Cascaded H-Bridge Based STATCOM
27.Reduced Switch Count Step-up/Step-down Switched-Capacitor Three-Phase AC-AC Converter
28.Flexible Control of Photovoltaic Grid-Connected Cascaded H-Bridge Converters during Unbalanced Voltage Sags
29.Control of a PMSG Wind-Turbine under Asymmetrical Voltage Sags using Sliding Mode Approach
30.Analysis, Control and Design of Hybrid Grid-Connected Inverter for Renewable Energy Generation with Power Quality Conditioning
31.A Novel Design of PI Current Controller for PMSG-based Wind Turbine Considering Transient Performance Specifications and Control Saturation
32.Design and Implementation of Active Power Control with Improved P&O Method for Wind PV-Battery based Standalone Generation System
33.Design and Control of Autonomous Wind-Solar System with DFIG Feeding 3-Phase 4-Wire Loads
34.A Hybrid Resonant ZCS PWM Converter for Renewable Energy Sources Connecting to MVDC Collection System